How Much Does Brick Repair Cost in Pennsylvania?
One national cost guide puts most brick and masonry repair jobs at $500 to $2,500. Its national average is $2,000. A second guide puts brick wall repair at $803 to $2,660, with an average of $1,731. Per square foot, brick wall repair runs about $20 to $40.
In the first guide, reported jobs run from $250 at the small end to $6,500 at the top. Full restorations and rebuilt wall sections can cost far more. These are market numbers from national cost guides, not our price list. Our brick repair page covers the brick work we do around Pittsburgh.
What does brick repair cost by type of job?
The table pulls together published ranges from two national cost guides. Each guide prices the work a little differently, so some rows overlap. Both are national figures.
| Brick repair job | Published market range |
|---|---|
| Typical brick and masonry repair job | $500 to $2,500 |
| Brick wall repair, per square foot | $20 to $40 |
| Brick veneer repair, per square foot | $11 to $24 |
| Crack repair, 10 or fewer bricks | $500 or less |
| Spalling brick, up to 100 square feet | $1,000 to $3,500 |
| Spalling brick, small sections | $250 to $450 minimum |
| Brick steps, per step | $300 to $750 |
| Brick stoop of 3 to 5 steps, replaced | $1,500 to $4,400 |
| Brick porch, repointing and small sections | $1,500 to $3,000 |
| Minor brick foundation repair | $500 to $2,000 |
| Bricking up a window or door | $600 to $1,500 |
| Lintel replacement over a window | $500 to $700 |
| Full brick restoration | $5,000 to $35,000 |
The second guide sorts jobs by the damage. Crack repairs run $500 or less for 10 or fewer bricks, and $750 to $1,000 when several areas are cracked. Spalling runs $900 to $1,200 when only a few sections need work. It can run as high as $20,000 when large sections of a wall have to be rebuilt.
For a rebuilt section of wall, the square foot rate does the math. At $20 to $40 per square foot, 100 square feet of brick wall repair comes to $2,000 to $4,000. Full restorations run $5,000 to $20,000 or more in the second guide.
Minor brick foundation repairs run $500 to $2,000. One guide says that work often includes digging, repointing the wall, laying new brick and repairing masonry below ground level. That work sits with our foundation repair and waterproofing service.
What drives brick repair cost?
How much brick has to come out comes first. Some masons set a minimum fee, usually $200 to $400 in one guide. A handful of bricks can cost more per brick than a big patch.
Height and access come next. One guide adds 20 to 40 percent for work on two-story buildings. The other adds 10 to 25 percent for hard-to-reach repairs more than 10 feet off the ground. Both tie the extra cost to scaffolding.
Matching comes third. On an older house, finding brick that matches the wall can take some looking. One guide puts mortar color-match testing at $150 to $325, and says detailed or patterned brickwork adds labor time.
The mortar and the cause of the damage round out the list. If either one is wrong, the damage keeps going after the repair.
Is it a brick pointing job or a brick repair job?
Brick pointing fixes the mortar joints between the bricks. One cost guide says pointing only works when the damage is limited to the joints. Loose or cracked brick and spalled faces need brick repair. That guide puts replacing deteriorating brick at $20 to $30 per square foot.
National Park Service Preservation Brief 2, the federal guide to repointing old masonry, makes the same point. It says it is wrong to assume repointing alone will fix problems that come from somewhere else. If the joints are the only problem, read about brick pointing and our guide to what brick pointing costs.
Why does the cause of brick damage have to be fixed too?
Spalling is mostly a water problem. One guide says water freezing and thawing inside bricks causes most spalling. Cold Pittsburgh winters give that cycle plenty of chances.
Preservation Brief 2 lists the root causes behind failing masonry. They include leaking roofs or gutters, settling of the building, ground water wicking up the wall and extreme weather exposure. The brief says those should always be dealt with before the work begins. Without that fix, the decay goes on and the repointing is a waste of time and money.
One cost guide says the same about spalled brick. The moisture problem or the wrong mortar has to be fixed along with the brick.
Mortar harder than the brick is another cause. The brief says a mortar stronger than the brick pushes the wall’s stresses into the brick itself. The result is permanent damage, such as cracking and spalling. Salt adds to it, since salt crystallizing inside a brick creates pressure that can spall off parts of its face.
How does Pittsburgh’s older housing change the job?
Pittsburgh’s homes are old. The median home in the city was built in 1942, and nearly half were built before 1940. In California, PA, a Washington County borough, nearly three in ten homes were built before 1940.
On an old wall, the new mortar has to suit the old brick. Preservation Brief 2 says it should be softer or more permeable than the brick. One guide prices a mortar composition test for historic repairs at $300 to $500.
Painted brick on an older house can bring in federal lead rules. When work disturbs lead-based paint in a home built before 1978, EPA rules require a lead-safe certified firm. Davis Demolition and Masonry is an EPA Lead-Safe Certified Firm.
Chimney brick is its own job, since the roof and the height come into it. Our chimney repair and removal page covers that work.
When does a brick wall need a structural engineer first?
Some cracks are only cosmetic. One guide says hairline cracks on a few bricks are typically cosmetic surface damage. Long horizontal cracks and stair-step cracks typically point to foundation problems. That guide says they call for an inspection by a structural engineer.
A bowing wall is a bigger job. The second guide says to consult a structural engineer about bowing caused by major movement, such as a settling foundation. Bowing wall repair runs $2,000 to $6,500 per 100 square feet in one guide, $7,500 to $40,000 in the other.
A failed lintel is another warning sign. A lintel is the steel or concrete beam over a window or door in a brick wall. When one fails, a structural engineer should look at it first. One guide puts a lintel replacement at $500 to $700 over a window and $1,000 to $5,000 above a garage.
In each case, the engineer’s findings set the repair. Then we do the masonry work the repair calls for.
How do you get a price on brick repair around Pittsburgh?
Cost guides give you a bracket, and your price comes from the wall itself. That means how much brick is bad and why it failed. It also means how high the work sits and how hard the brick is to match.
Davis Demolition and Masonry is based in Pittsburgh and works about 40 miles around. That covers the city, the South Hills, the eastern suburbs and Washington and Westmoreland counties. Brick pointing and brick repair are the masonry work we do most.
We replace spalled and cracked brick and rebuild wall sections, steps and porch piers. We also brick in old openings and cut new ones. We look at the job and give you a price before any work starts.
We keep you posted during the job and leave the site clean. Call or text (412) 720-1866, or read more on our brick repair service page.